2013 Nissan Xterra Owner's Manual - Page 111

2013 Nissan Xterra Manual

Page 111 highlights

ELECTRONIC LOCKING REAR DIFFERENTIAL (E-Lock) SYSTEM SWITCH (if so equipped) ● the 4WD switch must be in the 4H position and the vehicle speed must be under 21 MPH (35 km/h), and ● the hill descent control system switch must be ON. The hill descent control system on indicator light will come on when the system is activated. Also, the stop/tail lights illuminate while the hill descent control system applies the brakes to control vehicle speed. If the accelerator or brake pedal is depressed while the hill descent control system is on, the system will stop operating temporarily. As soon as the accelerator or brake pedal is released, the hill descent control system begins to function again if the hill descent control operating conditions are fulfilled. The hill descent control system on indicator light blinks if the switch is on and all conditions for system activation are not met or if the system becomes disengaged for any reason. To turn off the hill descent control system, push the switch to the OFF position. For additional information, see "Hill descent control system on indicator light" earlier in this section and "Hill descent control system" in the "Starting and driving" section of this manual. When the E-Lock switch is turned ON, the indicator light will flash until the system engages. However, if all operation conditions listed above are not met or the system becomes disengaged, the indicator light will continue to flash. The Anti-Lock Brake (ABS) system is disabled and the ABS light illuminates when the E-Lock system is ON. Also, the Vehicle Dynamic Control (VDC) system is disabled and the VDC light illuminates when the E-Lock system is ON. See "Electronic locking rear differential (E-Lock) system" in the "Starting and Driving" section for further explanation and system limitations. LIC0729 The Electronic Locking Rear Differential (E-Lock) system can help provide added traction if the vehicle is stuck or becoming stuck. To activate the E-Lock system: ● the 4WD switch must be in the 4LO position (4-wheel drive vehicles), ● the vehicle must be stopped or moving at 4 MPH (7 km/h) or less, and ● the E-Lock system switch must be turned ON. WARNING ● Never leave the E-Lock system ON when driving on paved or hard-surfaced roads. Turning the vehicle may result in the rear wheels slipping and result in an accident and personal injury. After using the E-Lock system to free the vehicle, turn the system OFF. 2-34 Instruments and controls

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
  • 123
  • 124
  • 125
  • 126
  • 127
  • 128
  • 129
  • 130
  • 131
  • 132
  • 133
  • 134
  • 135
  • 136
  • 137
  • 138
  • 139
  • 140
  • 141
  • 142
  • 143
  • 144
  • 145
  • 146
  • 147
  • 148
  • 149
  • 150
  • 151
  • 152
  • 153
  • 154
  • 155
  • 156
  • 157
  • 158
  • 159
  • 160
  • 161
  • 162
  • 163
  • 164
  • 165
  • 166
  • 167
  • 168
  • 169
  • 170
  • 171
  • 172
  • 173
  • 174
  • 175
  • 176
  • 177
  • 178
  • 179
  • 180
  • 181
  • 182
  • 183
  • 184
  • 185
  • 186
  • 187
  • 188
  • 189
  • 190
  • 191
  • 192
  • 193
  • 194
  • 195
  • 196
  • 197
  • 198
  • 199
  • 200
  • 201
  • 202
  • 203
  • 204
  • 205
  • 206
  • 207
  • 208
  • 209
  • 210
  • 211
  • 212
  • 213
  • 214
  • 215
  • 216
  • 217
  • 218
  • 219
  • 220
  • 221
  • 222
  • 223
  • 224
  • 225
  • 226
  • 227
  • 228
  • 229
  • 230
  • 231
  • 232
  • 233
  • 234
  • 235
  • 236
  • 237
  • 238
  • 239
  • 240
  • 241
  • 242
  • 243
  • 244
  • 245
  • 246
  • 247
  • 248
  • 249
  • 250
  • 251
  • 252
  • 253
  • 254
  • 255
  • 256
  • 257
  • 258
  • 259
  • 260
  • 261
  • 262
  • 263
  • 264
  • 265
  • 266
  • 267
  • 268
  • 269
  • 270
  • 271
  • 272
  • 273
  • 274
  • 275
  • 276
  • 277
  • 278
  • 279
  • 280
  • 281
  • 282
  • 283
  • 284
  • 285
  • 286
  • 287
  • 288
  • 289
  • 290
  • 291
  • 292
  • 293
  • 294
  • 295
  • 296
  • 297
  • 298
  • 299
  • 300
  • 301
  • 302
  • 303
  • 304
  • 305
  • 306
  • 307
  • 308
  • 309
  • 310
  • 311
  • 312
  • 313
  • 314
  • 315
  • 316
  • 317
  • 318
  • 319
  • 320
  • 321
  • 322
  • 323
  • 324
  • 325
  • 326
  • 327
  • 328
  • 329
  • 330
  • 331
  • 332
  • 333
  • 334
  • 335
  • 336
  • 337
  • 338
  • 339
  • 340
  • 341
  • 342
  • 343
  • 344
  • 345
  • 346
  • 347
  • 348
  • 349
  • 350
  • 351
  • 352
  • 353
  • 354
  • 355
  • 356
  • 357
  • 358
  • 359
  • 360
  • 361
  • 362
  • 363
  • 364
  • 365
  • 366
  • 367
  • 368
  • 369
  • 370
  • 371
  • 372
  • 373
  • 374
  • 375
  • 376
  • 377
  • 378
  • 379
  • 380
  • 381
  • 382
  • 383
  • 384
  • 385
  • 386
  • 387
  • 388
  • 389
  • 390
  • 391
  • 392
  • 393
  • 394

the4WDswitchmustbeinthe4Hposition
and the vehicle speed must be under
21MPH(35km/h),and
the hill descent control system switch must
beON.
Thehilldescentcontrolsystemonindicatorlight
willcomeonwhenthesystemisactivated.Also,
thestop/taillightsilluminatewhilethehilldescent
control system applies the brakes to control ve-
hiclespeed.
If the accelerator or brake pedal is depressed
while the hill descent control system is on, the
system will stop operating temporarily. As soon
astheacceleratororbrakepedalisreleased,the
hill descent control system begins to function
againifthehilldescentcontroloperatingcondi-
tionsarefulfilled.
Thehilldescentcontrolsystemonindicatorlight
blinks if the switch is on and all conditions for
system activation are not met or if the system
becomesdisengagedforanyreason.
To turn off the hill descent control system, push
theswitchtotheOFFposition.
Foradditionalinformation,see“Hilldescentcon-
trol system on indicator light”earlier in this sec-
tion and “Hill descent control system” in the
“Startinganddriving”sectionofthismanual.
TheElectronicLockingRearDifferential(E-Lock)
system can help provide added traction if the
vehicleisstuckorbecomingstuck.
ToactivatetheE-Locksystem:
the4WDswitchmustbeinthe4LOposition
(4-wheeldrivevehicles),
the vehicle must be stopped or moving at
4MPH(7km/h)orless,and
the E-Lock system switch must be turned
ON.
WhentheE-LockswitchisturnedON,theindi-
cator light will flash until the system engages.
However,ifalloperationconditionslistedabove
arenotmetorthesystembecomesdisengaged,
theindicatorlightwillcontinuetoflash.
The Anti-Lock Brake (ABS) system is disabled
and the ABS light illuminates when the E-Lock
systemisON.Also,theVehicleDynamicControl
(VDC) system is disabled and the VDC light
illuminateswhentheE-LocksystemisON.
See“Electroniclockingreardifferential(E-Lock)
system”in the “Starting and Driving”section for
furtherexplanationandsystemlimitations.
WARNING
Never leave the E-Lock system ON
whendrivingonpavedorhard-surfaced
roads.Turningthevehiclemayresultin
therearwheelsslippingandresultinan
accident and personal injury. After us-
ing the E-Lock system to free the ve-
hicle,turnthesystemOFF.
LIC0729
ELECTRONICLOCKINGREAR
DIFFERENTIAL(E-Lock)SYSTEM
SWITCH(ifsoequipped)
2-34
Instrumentsandcontrols