2013 Nissan Xterra Owner's Manual - Page 185

FM/AM RADIO WITH COMPACT DISC (CD) PLAYER (if so equipped) For all operation precautions, see ЉAudio operation precautionsЉ in this section. Audio main operation Power button and VOL control knob Place the ignition switch in the ACC or ON position, then press the PWR (power) button. If you listen to the radio with the engine not running, place the ignition switch in the ACC position. The mode (radio or CD) that was playing immediately before the system was turned off resumes playing. When no CD is loaded, the radio comes on. Pressing the PWR button again turns the system off. Turn the VOL control knob to the right to increase volume or to the left to decrease volume. MENU button (BASS, TREBLE, FADE, BALANCE and CLOCK): Press the MENU button to change the mode as follows: BAS → TRE → FAD → BAL → CLOCK → Audio → BAS To adjust Bass, Treble, Fade and Balance, press the MENU button until the desired mode appears in the display. Press the SEEK button to adjust Bass and Treble to the desired level. You can also use the SEEK button to adjust Fade and Balance modes. Fade adjusts the sound level between the front and rear speakers and Balance adjusts the sound between the right and left speakers. Once you have adjusted the sound quality to the desired level, press the MENU button repeatedly until the radio or CD display reappears. Otherwise, the radio or CD display will automatically reappear after about 10 seconds. NOTE: If the clock is enabled, pressing the MENU button will change the mode as follows: BAS → TRE → FAD → BAL → CLOCK → Hour adjustment → Minute adjustment → Audio → BAS For more information on setting the clock, see "Clock set" later in this section. Clock operation Press the MENU button until CLOCK is displayed; use the SEEK button to turn the clock display on (CLK ON) or off (CLK OFF). Clock set If the clock is not displayed with the ignition switch in the ACC or ON position, you need to select the CLK ON mode. Press the MENU button repeatedly until CLOCK is displayed. Use the SEEK button to enable CLK ON mode. 1. Press the MENU button repeatedly until CLOCK mode appears; press the SEEK button until CLK ON appears. 2. Press the MENU button again; the hours will start flashing. 3. Press the SEEK button adjust the hour. or to 4. Press the MENU button again; the display will switch to the minute adjustment mode. 5. The minutes will start flashing. Press SEEK button or to adjust the minutes. 6. Press the MENU button again to exit the clock set mode. The display will return to the regular clock display after 10 seconds, or press the MENU button again to return to the regular clock display. 4-40 Monitor, climate, audio, phone and voice recognition systems