2013 Nissan Xterra Owner's Manual - Page 204
2013 Nissan Xterra Manual
Page 204 highlights
● Do not force the iPod® cable into the USB port. Inserting the USB device tilted or up-side-down into the port may damage the iPod® cable and the port. Make sure that the iPod® cable is connected correctly into the USB port. (Some iPod® cables come with a mark as a guide. Make sure that the mark is facing the correct direction before inserting the iPod® cable.) ● Do not locate objects near the iPod® cable to prevent the objects from leaning on the iPod® cable and the port. Pressure from the objects may damage the iPod® cable and the port. To connect an iPod® to the vehicle so that the iPod® can be controlled with the audio system controls and display screen, use the USB jack 1 . Connect the located in the center console ᭺ iPod®-specific end of the cable to the iPod® and the USB end of the cable to the USB jack on the vehicle. If your iPod® supports charging via a USB connection, its battery will be charged while connected to the vehicle with the ignition switch in the ACC or ON position. While connected to the vehicle, the iPod® can only be operated by the vehicle audio controls. To disconnect the iPod® from the vehicle, remove the USB end of the cable from the USB jack on the vehicle, then remove the cable from the iPod®. * iPod® is a trademark of Apple Inc., registered in the U.S. and other countries. ● iPod® Nano - 5th generation (16GB) (firmware version 1.0.1PC or later) ● iPod® Nano - 6th generation (8GB) (firmware version 1.2PC or later) ● iPod® Nano - 6th generation (8GB) (firmware version 1.1PC or later) ● iPod® Touch - 1st generation (firmware version 2.2.1 or later) ● iPod® Touch - 2nd generation (firmware version 2.2.1 or later) ● iPod® Touch - 3rd generation (firmware version 3.1.3 or later) ● iPod® Touch - 4th generation (firmware version 4.3.5 or later) ● iPhone® 3G (firmware version 4.1 or later) ● iPhone® 3GS (firmware version 4.3 or later) ● iPhone® 4 (firmware version 5.0 or later) ● iPhone® 4S (firmware version 5.1 or later) ● iPad® (firmware version 4.3.2 or later) ● iPad® 2 (firmware version 4.3.3 or later) Make sure that your iPod® firmware is updated to the version indicated above. Compatibility The following models are compatible: ● iPod® 5th Generation (firmware version 1.3 or later) ● iPod® Classic (80GB) (firmware version 1.1.2PC or later) ● iPod® Classic (120GB) (firmware version 2.0.1PC or later) ● iPod® Nano - 1st generation (firmware version 1.3.1 or later) ● iPod® Nano - 2nd generation (firmware version 1.1.3 or later) ● iPod® Nano - 3rd generation (firmware version 1.1.3PC or later) ● iPod® Nano - 4th generation (firmware version 1.0PC or later) ● iPod® Nano - 5th generation (8GB) (firmware version 1.0.2PC or later) Monitor, climate, audio, phone and voice recognition systems 4-59