2014 Nissan Murano Owner's Manual - Page 132

WARNING SYSTEMS SWITCH (if so equipped) light goes off. The heater is controlled by a thermostat, automatically turning the heater on and off. The indicator light will remain on as long as the switch is on. When the vehicle's interior is warmed, or before you leave the vehicle, be sure to turn off the switch. SIC2770 SSD1156 The seats are warmed by built-in heaters. The switches located on the center console and rear doors (if so equipped for rear seats) can be operated independently of each other. 1. Start the engine. 2. Select heat range. 1 For high heat, push the HI (High) side of * The warning systems switch is used to temporarily turn off the warning systems (Lane Departure Warning (LDW) and Blind Spot Warning (BSW) systems) that are activated on the center display. When the warning systems switch is turned off, 1 the indicator * on the switch is off. The indicator will also be off if all of the warning systems are deactivated using the center display. The BSW system will turn on the Blind Spot Indicator lights, located inside the outside mirrors, if a vehicle is located in the detection zone. If the turn signal is activated in the direction of the detected vehicle, a chime Instruments and controls 2-43 the switch. the switch. 2 For low heat, push the LO (Low) side of * 3 * The indicator light in the switch illuminate when the heater is on. will 3. To turn off the heater, return the switch to the level position. Make sure the indicator