2014 Nissan Murano Owner's Manual - Page 154
2014 Nissan Murano Manual
Page 154 highlights
4. At the receiver located on the garage door opener motor in the garage, locate the "learn" or "smart" button (the name and color of the button may vary by manufacturer but it is usually located near where the hanging antenna wire is attached to the unit). If there is difficulty locating the button, reference the garage door opener's manual. 5. Press and release the "learn" or "smart" button. NOTE: Once the button is pressed, you have approximately 30 seconds to initiate the next step. 6. Return to the vehicle and firmly press and hold the programmed HomeLink® button for two seconds and release. Repeat the "press/hold/release" sequence up to 3 times to complete the programming process. HomeLink® should now activate your rolling code equipped device. 7. If you have any questions or are having difficulty programming your HomeLink® buttons, refer to the HomeLink® web site at: www.homelink.com or call 1-800-3553515. PROGRAMMING HomeLink® FOR CANADIAN CUSTOMERS AND GATE OPENERS Canadian radio-frequency laws require transmitter signals to "time-out" (or quit) after several seconds of transmission - which may not be long enough for HomeLink® to pick up the signal during programming. Similar to this Canadian law, some U.S. gate operators are designed to "time-out" in the same manner. If you live in Canada or you are having difficulties programming a gate operator or garage door opener by using the "Programming HomeLink®" procedures, replace "Programming HomeLink®" Step 2 with the following: NOTE: When programming a garage door opener, etc., unplug the device during the "cycling" process to prevent possible damage to the garage door opener components. Step 2: Using both hands, simultaneously press and hold the desired HomeLink® button and the hand-held transmitter button. During programming, your hand-held transmitter may automatically stop transmitting. Continue to press and hold the desired HomeLink® button while you press and re-press ("cycle") your hand-held transmitter every two seconds until the frequency signal has been learned. The HomeLink® Instruments and controls 2-65 JVI0429X 3. Press and hold the programmed HomeLink® button and observe the indicator light. . If the indicator light * 1 is solid/continuous, programming is complete and your device should activate when the HomeLink® button is pressed and released. . If the indicator light * 1 blinks rapidly for two seconds and then turns to a solid/ continuous light, continue with Steps 4-6 for a rolling code device. A second person may make the following steps easier. Use a ladder or other device. Do not stand on your vehicle to perform the next steps.