2014 Nissan Murano Owner's Manual - Page 209
2014 Nissan Murano Manual
Page 209 highlights
Initialize entry/exit function If the battery cable is disconnected, or if the fuse opens, the entry/exit function will not work though this function was set on before. In such a case, after connecting the battery or replacing with a new fuse, open and close the driver's door more than two times after the ignition switch is placed in the LOCK position from the ON position. The entry/exit function will be activated. system" section and "Tilt/telescopic steering" earlier in this section and "Outside mirrors" earlier in this section. 4. Push the SET switch and, within 5 seconds, push the memory switch (1 or 2). The indicator light for the pushed memory switch will stay on for approximately 5 seconds after pushing the switch. If memory is stored in the same memory switch, the previous memory will be deleted. SPA2756 Linking Intelligent Key to a stored memory position The Intelligent Key can be linked to a stored memory position with the following procedure. 1. Follow one of the steps for storing a memory position. While the indicator light for the memory switch being set is illuminated for 5 seconds, push the button on the Intelligent Key. . Push the ignition switch to the OFF position, and then push the SET switch. Push the button while pushing the memory button while the indicator light stays on for approximately 5 seconds. If the indicator light blinks, the Intelligent Key is linked to that memory setting. . MEMORY STORAGE Two positions for the driver's seat, steering column (if so equipped) and outside mirrors can be stored in the automatic drive positioner memory. Follow these procedures to use the memory system. 1. Move the shift lever to the P (Park) position. 2. Push the ignition switch to the ON position. 3. Adjust the driver's seat, steering column (if so equipped) and outside mirrors to the desired positions by manually operating each adjusting switch. For additional information, see "Seats" in the "1. Safety - Seats, seat belts and supplemental restraint 3-52 Pre-driving checks and adjustments