1998 Pontiac Sunfire Owner's Manual - Page 79

Replacing the Battery in the Remote Keyless Entry System Transmitter 3. Read the instructions inside the case. 4. Put the two halves back together. Make sure the cover is on tightly, so water won't get in. 5. Check the operation of the transmitter with your vehicle. If the transmitter does not work, try synchronizing the transmitter with the receiver. Synchronization Your remote keyless entry system is equipped with a security system that prevents anyone from recording and playing back your signal. The transmitter does not send the samesignal twice to the receiver. The receiver will not respond to a signal that has been sentitto more than once. To resynchronize your transmitter and receiver, follow these directions: To replace the battery in the transmitter: 1. Stand close to your vchicle. 2 . Press and hold the LOCK and UNLOCK buttons on the transmitter at thesame time. 1. Use a small coin or flathead screwdriver to separate the bottom halffrom the top half of the transmitter. 2. Remove the battery and replace it with the new one. Make sure the positive (+) side of the battery faces down. For battery replacement,use a 3-volt battery, type CR2032, or equivalent. 3. Hold the buttons for at least five seconds. During this time, the doorsshould lock and unlock once. This confirms the resynchronization. If the doors do not lock and unlock, see your dealer for service. - 2-9