AIWA CSD-ED87 Operating Instructions - Page 7

VOLUME Press VOLUME A or V. The volume level is displayed as a number from O to MAX (25). q The volume level is automatically set to 14 if the power is turned off when the volume level is set to 15 or more. To display the volume level when a function other than TAPE function is selected Press VOLUME A or V. The volume level is displayed for 4 seconds. DISPLAY on the remote control is also available. 3-MODE EQUALIZEI? Press * 3-MODE EQUALIZER until one of the indicators lights up. The equalizer mode changes to ROCK, POP, JAZZ or no equalization, cyclically. ROCK - Emphasizes the high and low range of music. POP - Emphasizes voice and midrange of music. JAZZ - Emphasizes the low range of music. * or EQ on the remote control T-BASS system The T-BASS system enhances the realism of lowfrequency sound. Press T-BASS and the T-BASS indicator lights up. QSOUND system This system provides a rich, three dimensional sound area for stereo sources. You can enjoy more enhanced sound. Press QSOUND and the QSOUND indicator lights up. c At higher volumes, turning QSOUND on may cause sound distortion. In this case, turn the volume down. The unit can be turned off automatically at a specified time. q While CD function is selected, operate the following procedures in stop mode. Press REPEAT/FM lVIODE/OSC ~=d pressing STOP/MEMORY ~. while If STOP/MEMORY is kept pressed, another operation may start. Within 4 seconds, press [++ or M to specify the time until the power is turned off. Each time it is pressed, the time changes between 10 and 90 minutes in 10-minute steps. Specified time While the sleep timer works, the dot keeps flashing. To check the time remaining until the power is turned off Repeat step 1 shown above. The remaining time is displayed for 4 seconds. To cancel the sleep timer Display the remaining time and press M repeatedly until OFF is displayed. or *I NOTE If the unit is turned off during tape playback, + on the deck will not be released. Press WA to release +. If an erroneous display or malfunction occurs Make sure that none of the deck operation buttons is pressed. Press 9 while pressing POWER (!) STANDBY. If the unit cannot be reset in the way above, disconnect the AC cord and remove all the batteries to turn off the display. Leave the unit for a while and turn the power back on. Maintenance To clean the cabinet Use a soft cloth lightly mclistened with mild detergent solution. Do not use strong solvents such as alcohol, benzine or thinner. To clean the heads When the tape heads are dirty; - high frequency sound is not emitted - the sound is not adequi~tely high - the sound is off-balance - the tape cannot be erased - the tape cannot be recorded on After every 10 hours of use, clean the tape heads with a head cleaning cassette. Use separately sold dry-type or wet-type cleaning cassette. Refer to the instructions c)f the cleaning cassette for details. Lens To clean the lens Use a cotton swab slightly moistened with cleaning fluid. Wipe gently from the center to the edge. ENGLISH ~