Alpine CDE-125BT Owner's Manual (english) - Page 34
Left Rear - Speaker Output Lead Green/Black - harness
UPC - 793276711700
View all Alpine CDE-125BT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 34 highlights
Antenna Receptacle Power Antenna Lead (Blue) Connect this lead to the +B terminal of your power antenna, if applicable. • This lead should be used only for controlling the vehicle's power antenna. Do not use this lead to turn on an amplifier or a signal processor, etc. Remote Turn-On Lead (Blue/White) Connect this lead to the remote turn-on lead of your amplifier or signal processor. Audio Interrupt In Lead (Pink/Black) Not used for this unit. Illumination Lead (Orange) This lead may be connected to the vehicle's instrument cluster illumination lead. This will allow the backlighting of this unit to dim whenever the vehicle's lights are turned on. Switched Power Lead (Ignition) (Red) Connect this lead to an open terminal on the vehicle's fuse box or another unused power source which provides (+)12V only when the ignition is turned on or in the accessory position. Battery Lead (Yellow) Connect this lead to the positive (+) post of the vehicle's battery. Ground Lead (Black) Connect this lead to a good chassis ground on the vehicle. Make sure the connection is made to bare metal and is securely fastened using the sheet metal screw provided. Power Supply Connector Right Front (+) Speaker Output Lead (Gray) Right Front (-) Speaker Output Lead (Gray/Black) Right Rear (-) Speaker Output Lead (Violet/Black) Right Rear (+) Speaker Output Lead (Violet) Left Rear (+) Speaker Output Lead (Green) Left Rear (-) Speaker Output Lead (Green/Black) Left Front (-) Speaker Output Lead (White/Black) Left Front (+) Speaker Output Lead (White) Fuse Holder (10A) Front Output RCA Connectors (CDE-126BT only) RED is right and WHITE is left. Rear/Subwoofer Output RCA Connectors (CDE-126BT only) Front/Subwoofer Output RCA Connectors (CDE-125BT only) RED is right and WHITE is left. MIC Input Connector To Microphone. RCA Extension Cable (sold separately) Full Speed Connector Control iPod/iPhone signals. Connect this to an iPod/iPhone by using FULL SPEED Connection Cable (KCE-433iV) (Supplied, CDE-126BT only) or to an external device (such as a portable player) by using conversion cable (KCE-237B) for building up the AUX IN (sold separately). • Refer to "Setting the AUX+ SETUP Mode" (page 19). AUX+ ON : When the external device is connected. AUX+ OFF : When an iPod/iPhone is connected. FULL SPEED Connection Cable (KCE-433iV) (Supplied, CDE-126BT only) Front AUX Input Terminal This terminal allows for input of audio from an external device (such as a portable player), using a commerciallyavailable converter cable. USB Connection Terminal Connect USB memory (sold separately) To prevent external noise from entering the audio system. • Locate the unit and route the leads at least 10 cm away from the car harness. • Keep the battery power leads as far away from other leads as possible. • Connect the ground lead securely to a bare metal spot (remove any paint, dirt or grease if necessary) of the car chassis. • If you add an optional noise suppressor, connect it as far away from the unit as possible. Your Alpine dealer carries various noise suppressors, contact them for further information. • Your Alpine dealer knows best about noise prevention measures so consult your dealer for further information. 34-EN