Alpine IDAX001 Owners Manual - Page 36

Front Frame Remove the iPod Remove the iPod from FULL SPEED™ Connection Cable or iPod Dock interface cable. This unit Ground Lead *3 Screws (M5 × 8) (Included) Mounting Bracket • Secure the ground lead of the unit to a clean metal spot using a screw (*3) already attached to the vehicle's chassis. USB cable connection Insert a USB cable into the unit, and fix with a lock screw. • If USB is connected, after the unit has been changed to a source other than the iPod, remove the iPod. If the iPod is removed in the iPod mode, data may cause damage. • If sound is not output or the iPod is not recognized even when the iPod is connected, remove the iPod once, then connect it again, or reset the iPod. USB memory Connection (sold separately) Connect USB memory Connect USB memory to USB cable. USB cable USB Cable USB memory Remove USB memory Pull out USB memory squarely from the USB cable. USB cable iPod Connection (sold separately) USB connection Connect USB cable to an iPod with iPod Dock interface cable. USB cable USB memory • When removing USB memory, pull it out straight. • If sound is not output or USB memory is not recognized even when USB memory is connected, remove USB memory once, then connect it again. • Change to a source other than the USB memory mode, then remove the USB memory. If the USB memory is removed in the USB memory mode, data may be damaged. iPod Dock interface Cable Direct connection Connect iPod direct connector to an iPod with FULL SPEEDTM connection cable (KCE-422i). FULL SPEED™ Connection Cable (KCE-422i) (Sold separately) 34-EN