Alpine INA-W900 Owner's Manual (English) - Page 93

Installation Caution Do not block the unit's fan or heat sink, thus preventing air circulation. If blocked, heat will accumulate inside the unit and may cause a fire. Air ventilation hole Air ventilation hole Rear of the Unit Top of the Unit Caution concerning the installation location 1 Before installing, make sure that the opening and closing of the display will not interfere with operation of the gear shift. Movable Display 3 Remove the mounting sleeve from the main unit (see "Removal" on page 92). The unit can be installed in the mounting sleeve in three positions by aligning its mounting holes (A to C) on the sides of the unit. Position A will be used in most cases. If B or C are to be used, the hole positions need to be modified. First, determine the mounting position in the mounting sleeve, then affix the supplied seal (refer to "How to use a Seal" (page 92)). Slide the unit into the mounting sleeve and secure it. • If B or C is used, make sure that there is a enough space depthwise before installing the unit. If the unit is forcibly pushed into the mounting sleeve, damage may occur. Mounting Sleeve (Included) Dashboard This unit Seal (Included) Pressure Plates*1 Face Plate*2 (Included) Position B Position A Position C 2 Angle of installation About the installation angle, please install as horizontally as possible within the following angle range. If the installation angle is beyond the range, the current position may not be correctly displayed and a maloperation may be caused for the navigation mode. 0° Front of the unit 10°(±5°) Top of the unit 0-30° • Depending on the position chosen, the front panel will protrude differently. Front Panel Dashboard Position A Front Panel Dashboard Position B Front Panel Side of the unit Dashboard Position C *1 If the installed mounting sleeve is loose in the dashboard, the pressure plates may be bent slightly to remedy the problem. 91-EN