Alpine iDA-X305S Om Ida-x305s English - Page 37
Adjusting the Time Correction, Adjusting the Crossover Settings
UPC - 793276711687
View all Alpine iDA-X305S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
6 Repeat steps 3 to 5, and adjust each band level. Frequency Adjustment (F0) Band1 (63 Hz) / Band2 (150 Hz) / Band3 (400 Hz) / Band4 (1 kHz) / Band5 (2.5 kHz) / Band6 (6.3 kHz) / Band7 (17.5 kHz) Level Adjustment (Gain) Adjustable output level: -6 to +6 dB • During adjustment, if you press in the outer ring and rotate the Double Action encoder to the left or right, the band changes, and you can adjust the adjacent band. If you press then rotate and hold the Double Action encoder to the left or right, the band continuously changes. • The function is inoperable when Defeat is set to ON. Adjusting the Time Correction Sound Field Adjustment Time Correction Before performing the following procedures, refer to "About Time Correction" (page 37). 1 Rotate the Double Action encoder to select "Time Correction" in the Sound Field adjustment mode, and then press /ENTER. Depending on the X-OVER switch setting on the IMPRINT audio processor (PXA-H100), the speaker to be adjusted differs. 3WAY System High L / High R / Mid L / Mid R / Low L / Low R F/R/SUBW. System Front L / Front R / Rear L / Rear R / Subw. L / Subw. R 2 Rotate the Double Action encoder to select the speaker, and press /ENTER. Adjusting the Crossover Settings Sound Field Adjustment X-Over Before performing the following procedures, refer to "About the Crossover" (page 38). 1 Rotate the Double Action encoder to select "X-Over" in the Sound Field adjustment mode, and then press /ENTER. 2 Rotate the Double Action encoder to select the band, and then press /ENTER. If a band is selected, each band screen to be adjusted is displayed. 3WAY System / Normal (L=R) Setting items: Low/Mid-Low/Mid-High/High 3WAY System / Individual (L/R) Setting items: Low L/Low R/Mid-Low L/Mid-Low R/Mid-High L/ Mid-High R/High L/High R F/R/SUBW. System / Normal (L=R) Setting items: Subw./Rear/Front F/R/SUBW. System / Individual (L/R) Setting items: Subw. L/Subw. R/Rear L/Rear R/Front L/Front R • Depending on the current system, selectable band content differs. Refer to "Setting the Filter type" (page 34) and the setting of the X-OVER switch on the IMPRINT audio processor (PXA-H100). 3 Rotate the Double Action encoder to adjust the frequency/slope/level. The currently adjusted item lights up. Band Selected speakers 3 Rotate the Double Action encoder to set to the distance of each speaker. 0.0 cm~336.6 cm (0.0 inch~132.7 inch) 4 If /ENTER is pressed, the adjustment value is set, and the speaker selection mode is activated. 5 Repeat steps 2 to 4, and set the all speakers. • During adjustment, if you press in the outer ring and rotate the Double Action encoder to the left or right, the speaker changes, and you can adjust the adjacent band. If you press then rotate and hold the Double Action encoder to the left or right, the speaker continuously changes. You can also change the speaker by pressing BAND. Cut-off frequency Slope Level 4 The adjustment content is selected by pressing /ENTER, and operation shifts to a next adjustment item. 5 When the selected band settings are complete, press BAND. The next band adjustment screen is displayed. 6 Set all bands by repeating steps 3 to 5. 35-EN