Asko DC7583 User manual 427000608 ASKO DC7573 EN - Page 26

Troubleshooting The machine will not start Check • that the door is closed properly. • that the main power switch is on. • that the machine is not programmed to start at a specific time (e.g., 13:30) • that any plug is connected. • that the fuses (circuit breakers) in your house are intact. Flip the dryer breaker off and then back on to make sure. You can not always tell from the outside if the circuit breaker has tripped. • that the overheating cut-off has not been triggered (see below). Overheating cut-off The overheating cut-out shuts off the drying cabinet if the temperature is too high. • The overheating cut-off will reset automatically once the machine has cooled down. Drying takes too long • Poorly spun or very wet laundry. • The drying cabinet is positioned in an area where the ambient temperature is too low. The garments do not dry, or are too dry • The door has been opened while the program is running, which disrupts the moisture monitoring function. • The garments may not have been hung correctly, obstructing the air flow. See "Garment placement" in the "Operation" chapter. • Wrong program selected, choose another program, see the "Operation" chapter. • Poorly spun laundry or very wet laundry. • The vent pipe/hose is too long. The length should not exceed 39" (1 m). • Normal operation requires installation in a room with a temperature above 32 °F (0 °C). Error messages If F2 flashes on the display, the maximum permitted program time has been reached. Read "Drying takes too long" in the "Troubleshooting" chapter to find out what to do. 24 Customer Care Center 1-800-898-1879 www.askousa.com