Asus A7V600 SE Motherboard DIY Troubleshooting Guide - Page 36
System Power LED Lead 3-1 pin PLED
View all Asus A7V600 SE manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
12. Serial ATA connector (7 pin SATA1, SATA2) These connectors accommodate the primary serial ATA (SATA1) and a secondary serial ATA (SATA2) cables. Connect the serial ATA cable to this connector then install to a serial ATA ready hard disk. A7V600 SE ® A7V600 SE SATA Connectors SATA2 SATA1 GND RSATA_TXP2 RSATA_TXN2 GND RSATA_RXP2 RSATA_RXN2 GND GND RSATA_TXP1 RSATA_TXN1 GND RSATA_RXP1 RSATA_RXN1 GND 13. System panel connector (20-pin PANEL1) This connector accommodates several system front panel functions. Power LED Speaker Connector PLED+ PLED+5V Ground Ground Speaker IDE_LED+ IDE_LED- ExtSMI# Ground PWR Ground Reset Ground A7V600 SE Reset SW IDE_LED ATX Power ® SMI Lead Switch* * Requires an ATX power supply. A7V600 SE System Panel Connectors • System Power LED Lead (3-1 pin PLED) This 3-1 pin connector connects to the system power LED. The LED lights up when you turn on the system power, and blinks when the system is in sleep mode. • System Warning Speaker Lead (4-pin SPKR) This 4-pin connector connects to the case-mounted speaker and allows you to hear system beeps and warnings. • Reset Switch Lead (2-pin RESET) This 2-pin connector connects to the case-mounted reset switch for rebooting the system without turning off the system power. 1-26 Chapter 1: Motherboard Information