Asus RS100-E10-PI2 User Manual - Page 110
Network Stack Configuration, Device power-up delay [Auto], Mass Storage Devices
View all Asus RS100-E10-PI2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 110 highlights
Device power-up delay [Auto] Allows you to set the maximum time the device takes before the device reports itself to the host controller properly. Configuration options: [Auto] [Manual] The following item appears only when you set Device power-up delay to [Manual]. Device power-up delay in seconds [5] Allows you to set the device power-up delay in seconds. Use the or to adjust the value. The values range from 1 to 40. Mass Storage Devices Allows you to select the mass storage device emulation type for devices connected. Configuration options: [Auto] [Floppy] [Forced FDD] [Hard Disk] [CD-ROM] 5.5.12 Network Stack Configuration Allows you to configure the network stack configuration. Network Stack [Disabled] Allows you to enable or disable UEFI Network Stack. Configuration options: [Disabled] [Enabled] The following items appear only when you set Network Stack to [Enabled]. Ipv4 PXE Support [Disabled] Enables or disables the Ipv4 PXE Boot Support. If disabled, Ipv4 PXE boot option will not be created. Configuration options: [Disabled] [Enabled] Ipv4 HTTP Support [Disabled] Enables or disables the Ipv4 HTTP Boot Support. If disabled, Ipv4 PXE boot option will not be created. Configuration options: [Disabled] [Enabled] Ipv6 PXE Support [Disabled] Enables or disables the Ipv6 PXE Boot Support. If disabled, Ipv6 PXE boot option will not be created. Configuration options: [Disabled] [Enabled] Ipv6 HTTP Support [Disabled] Enables or disables the Ipv6 HTTP Boot Support. If disabled, Ipv6 PXE boot option will not be created. Configuration options: [Disabled] [Enabled] 5-24 Chapter 5: BIOS Setup