Asus TS100-E4 PI2 E2791 TS100-E4/PI2 User's Manual - Page 54
P5M2-M/C_TS100-E4 IDE Connector
View all Asus TS100-E4 PI2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 54 highlights
2. ICH7R primary IDE connector (40-1 pin PRI_IDE1) This connector is for an Ultra DMA 100/66 signal cable. The Ultra DMA 100/66 signal cable has three connectors: a blue connector for the primary IDE connector on the motherboard, a black connector for an Ultra DMA 100/66 IDE slave device (optical drive/hard disk drive), and a gray connector for an Ultra DMA 100/66 IDE master device (hard disk drive). If you install two hard disk drives, you must configure the second drive as a slave device by setting its jumper accordingly. Refer to the hard disk documentation for the jumper settings. • Pin 20 on the IDE connector is removed to match the covered hole on the Ultra DMA cable connector. This prevents incorrect insertion when you connect the IDE cable. • Use the 80-conductor IDE cable for Ultra DMA 100/66 IDE devices. PRI_IDE1 ® NOTE: Orient the red markings (usually zigzag) on the IDE ribbon cable to PIN 1. P5M2-M/C_TS100-E4 IDE Connector P5M2-M/C_TS100-E4 PIN 1 3-12 Chapter 3: Motherboard Information