Asus V6-P5G41E User Manual - Page 48
P5G41T-M LX2/GB Chassis intrusion connector, P5G41T-M LX2/GB fan connectors
View all Asus V6-P5G41E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 48 highlights
6. CPU and chassis fan connectors (4-pin CPU_FAN, 3-pin CHA_FAN) Connect the fan cables to the fan connectors on the motherboard, ensuring that the black wire of each cable matches the ground pin of the connector. DO NOT forget to connect the fan cables to the fan connectors. Insufficient air flow inside the system may damage the motherboard components. These are not jumpers! DO NOT place jumper caps on the fan connectors! P5G41T-M LX2/GB CHA_FAN Rotation +12V GND CPU_FAN CPU FAN PWM CPU FAN IN CPU FAN PWR GND P5G41T-M LX2/GB fan connectors Only the 4-pin CPU fan connector supports the ASUS Q-Fan feature. 7. Chassis intrusion connector (4-1 pin CHASSIS) This connector is for a chassis-mounted intrusion detection sensor or switch. Connect one end of the chassis intrusion sensor or switch cable to this connector. The chassis intrusion sensor or switch sends a high-level signal to this connector when a chassis component is removed or replaced. The signal is then generated as a chassis intrusion event. By default, the pins labeled "Chassis Signal" and "GND" are shorted with a jumper cap. Remove the jumper caps only when you intend to use the chassis intrusion detection feature. CHASSIS +5VSB_MB Chassis Signal GND P5G41T-M LX2/GB P5G41T-M LX2/GB Chassis intrusion connector 3-8 Chapter 3: Motherboard info