Binatone Acura 3000 User Guide - Page 4

2. Installation 1. Locating the Base unit The Base unit should be placed on a level surface, in a position where: „ the mains adapter plug will reach an easily accessible 230-V AC switched mains supply socket - never try to lengthen the mains power cable. „ the telephone line cable will reach your telephone line socket or extension socket. „ it is not close to a sink, bath or shower, or anywhere else where it might get wet. „ it is not close to other electrical equipment - fridges, washing machines, microwave ovens, TVs, fluorescent lights, etc. 2. Plug the coiled handset cord into the Handset. Plug the other end into the socket on the side of the Base unit. 3. Place the Handset on the Base unit. 4. Plug the telephone line cord into the PHONE LINE socket at the back of the Base unit. Plug the other end into your telephone line socket or extension socket. Make sure the plugs click into place. 5. Plug the power supply cord into the POWER jack at the back of the Base unit. Plug the other end into a 230V AC, 50Hz mains socket, with the switch on the socket set to OFF RINGER HI/LOW switch 6. Switch ON the mains power at to Telephone the socket. Wait while the line socket display shows INITIALISATION, Always use the telephone line cord supplied with your Phone. Other telephone line cords may not work. then the announcement "Answering machine on. Announcement one" before the display changes to the standby screen. Note: The Acura 3000 7.Lift the Handset and check Base unit must be used only with the AC power adapter for Dial tone in the earpiece. Shen Zhen G.EREDIT Electronics Co.,Ltd. 5E-AD070042-B. Note: The base unit doesn't require a battery. 4