Bosch TAS4515UC Instructions for Use - Page 17
Troubleshooting
View all Bosch TAS4515UC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
EN 15 Troubleshooting The following table provides solutions for problems and glitches that may arise as you use your TASSIMO machine. If you do not find a solution for your specific problem, or the problem persists after troubleshooting please contact TASSIMO Customer Service at 1-877-TDISCS1 (1-877-834-7271). ! Note: If piercing unit is missing, it may be purchased from TASSIMO or Bosch Customer Service Department at 1-877-TDISCS1 or only in the USA on www.tassimo.com. Problem Appliance not working; no symbols light up. Machine brews but no drink dispensed. O Automatic mode not working, appliance remains in stand-by mode. O Automatic mode skipped, appliance goes straight to N Manual mode. Possible cause There is no power supply. The water tank was removed during the brewing process or there is air in the system. The float in the water tank is stuck. No T DISC inserted. The barcode could not be detected. The barcode could not be detected. Solution Check that the appliance is properly plugged into the power supply. Replace the water tank in the appropriate position in your TASSIMO machine. Start a cleaning process with the Service T DISC. Clean the water tank and ensure the float can move. Check if T DISC has been inserted. Clean the bar code reading window and try again or smooth the barcode on the T DISC out with your thumb. Use another T DISC. If problems persist contact TASSIMO Customer Service Department at 1-877TDISCS1. Clean the bar code reading window. Use another T DISC. You can still prepare the drink by holding down the start /stop button. More Customer Service information is available online at www.tassimo.com 10/2010 TAS45 USA 101102.indd 15 02.11.2010 15:15:13