Brother International Entrepreneur Pro PR1000e Users Manual - English - Page 254
up, and then lower it so that the screw fits
View all Brother International Entrepreneur Pro PR1000e manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 254 highlights
APPENDIX Pull the table toward you until the pins on 3 the mounting brackets (attached on each side to the bottom of the table) fit into the notches in the guide plates. While looking below the table, lightly lift it 5 up, and then lower it so that the screw fits into the notch at the front of the guide plate. 1 Pin 2 Notch Slide in the table while supporting it so that 4 it remains level. Push the table in until it lightly touches the machine. • If the table does not move smoothly, slightly lift it up, and then slide it in. 1 Notch at front Tighten the two thumb screws so that the 6 table is secured. 1 Thumb screw 252
APPENDIX
————————————————————————————————————————————————————————————————————————————
252
3
Pull the table toward you until the pins on
the mounting brackets (attached on each
side to the bottom of the table) fit into the
notches in the guide plates.
1
Pin
2
Notch
4
Slide in the table while supporting it so that
it remains level. Push the table in until it
lightly touches the machine.
• If the table does not move smoothly,
slightly lift it up, and then slide it in.
5
While looking below the table, lightly lift it
up, and then lower it so that the screw fits
into the notch at the front of the guide plate.
1
Notch at front
6
Tighten the two thumb screws so that the
table is secured.
1
Thumb screw