Brother International Entrepreneur Pro PR1000e Users Manual - English - Page 267
Check that there is no looseness., Adjust the size of the mounting jig according, to the type size
View all Brother International Entrepreneur Pro PR1000e manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 267 highlights
Memo ● If there is a gap between the clamp of the thumb screw and the mounting surface, insert the included pad as shown below. ■ For the standard type Using a Phillips screwdriver, loosen the three screws (one each at the top and on the left and right sides) on the outside of the mounting jig two or three turns. 1 Mounting bracket 2 Mounting surface (worktable, desk, etc.) 3 Pad 4 Thumb screw Check that there is no looseness. 3 If there is looseness, mount the mounting jig onto the mounting surface again. Note ● Be sure that the mounting bracket is securely clamped onto the mounting surface and that the thumb screw is firmly tightened. ● Do not attach the mounting jig to an unstable surface (flexible, bent or warped). ● Be careful that the mounting jig does not fall when it is removed. Adjust the size of the mounting jig according 4 to the type (size) of cap being embroidered. 1 Screws 2 Phillips screwdriver Note ● Do not remove the three screws (one each at the top, left and right), otherwise they may be lost. Only turn the screws to slightly loosen them. 7 1 Low Profile (shorter caps) 2 Standard type (taller caps) Using the Optional Cap Frame 265