Brother International Innov-ís 4000D Users Manual - English - Page 72
Patchwork for Crazy Quilt, Sewing Curves Using a Zigzag, Stitch, Cord Guide Bobbin Cover Using a,
View all Brother International Innov-ís 4000D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 72 highlights
■ Patchwork (for Crazy Quilt) Turn back the desired width of fabric and position it over the lower fabric, then sew so that the stitch bridges both pieces of fabric. SEWING THE STITCHES c Snap the cord place, making guide bobbin cover into sure that the gimp thread can be fed freely. * Make sure there are no restrictions when feeding the thread. ■ Sewing Curves (Using a Zigzag Stitch) Shorten the stitch length setting to obtain a fine d Set the zigzag (approx. 1/16 width from 2.0-2.5 - 3/32 inch). mm 3 stitch. Sew slowly, keeping the seams parallel with Utility Stitches the fabric edge as you guide the fabric around the curve. e Attach presser foot "N". f Position the fabric right side up on top of the cord and place the cord to the rear of the machine under the presser foot. b a N ■ Cord Guide Bobbin Cover (Using a Zigzag Stitch) a Remove the bobbin cover from (see page 22). the machine b Thread the gimp thread through the hole the cord guide bobbin cover from top to in bottom. Position the thread in the notch at the back of the cord guide bobbin cover. a Fabric (right side) b Gimp thread g Lower the presser foot and make a decorative finish. start sewing to a b a Notch b Gimp thread 61