Brother International PC-210PRW Users Manual - English - Page 107
Error messages, Probable Cause, Symptom, Remedy, Reference
View all Brother International PC-210PRW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 107 highlights
CONTENTS GETTING READY SEWING BASICS UTILITY STITCHES Symptom The fabric does not feed. Probable Cause The feed dogs are lowered. The stitch is too fine. The presser foot that is used is not appropriate for the type of stitch that you wish to sew. The pressure of the presser foot is weak. The thread is tangled, for example, in the shuttle. The sewing lamp does not come on. The sewing lamp is damaged. Remedy Slide the drop feed lever to the left. Lengthen the stitch length. Attach the presser foot that is appropriate for the type of stitch that you wish to sew. Turn the presser foot pressure dial to the right to increase the pressure of the presser foot. Remove the tangle thread. If the thread is tangled in the shuttle, clean the shuttle. Contact your retailer or the nearest authorized service center. Reference page 67, 81 page 46 page 92 page 30 page 96 - Error messages If the start/stop button is pressed before the sewing machine is correctly set up or if an operation is performed incorrectly, an error message appears in the stitch indicator. Follow the instructions that appear. If you press (Stitch selection key) or do the operation correctly while the error message is displayed, the message disappears. Error Message Probable Cause The start/stop button or reverse/reinforcement stitch button was pressed while the presser foot was raised. A stitch other than the buttonhole or bar tack stitch was selected and the start/stop button was pressed while the buttonhole lever is lowered. The buttonhole or bar tack stitch was selected and the start/stop button was pressed while the buttonhole lever is raised. The reverse/reinforcement stitch button or needle position button was pressed while the bobbin winder shift is moved to the right. The start/stop button was pressed while the foot controller was connected. The motor locked up because the thread is tangled. APPENDIX INDEX Troubleshooting 101