Canon BJ-200 User Manual - Page 76
Command Summary., DIP switch 1
View all Canon BJ-200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 76 highlights
11 Printer control mode BJ-10 mode 12 Automatic emulation Disabled switching mode Epson LQ mode Enabled DIP switch 1 Use this switch to change the horizontal print position according to the size of your paper. If you are using letter-size paper or COM 10 envelopes, set this switch OFF; the left margin will be 0.25 inch (6.4 mm). If you are using A4-size paper or DL-size envelopes, set this switch ON; the left margin will be 0.13 inch (3.4 mm). DIP switch 2 If you are using a software application that assumes 66 lines will fit on each page, set this switch to ON. The printer will reduce the line spacing by a factor of 14/15, which is from 62 lines per page to 66 lines per page if line spacing is set to 6 lines per inch (lpi). DIP switch 3 If you are using letter-size paper, set this switch OFF; this sets the page length to 11 inches. If you are using A4-size paper, set this switch ON; this sets the page length to 12 inches. NOTE: In Epson LQ mode, you use this DIP switch with one-half reduction mode only. DIP switch 4 When this switch is OFF, the printer uses the Epson Italics character set, which includes italic characters. When this switch is ON, the printer uses the Epson Graphics character set, which is the same as the MS-DOS code page 437 (this character set includes symbols, lines, corners, and European characters). To see samples of the character sets available in Epson LQ mode, use Canon's toll-free fax retrieval system. Call the Canon help desk and request the fax retrieval system; then request the BJ-200e Printer Command Summary. DIP switches 5, 6, 7 These switches allow you to select one of eight international character sets. These character sets provide you with the characters and symbols used in other languages.