Canon LASER CLASS 650i Basic Operation Guide - Page 18
Installation Requirements and Handling, Temperature and Humidity Conditions, Power Supply Requirements
View all Canon LASER CLASS 650i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
Installation Requirements and Handling In order to use this machine in a safe and trouble-free manner, install the machine in a place that fulfills the following conditions. Also, read the remarks carefully. Temperature and Humidity Conditions • Temperature range: 50 to 86°F (10 to 30°C) • Humidity range: 20 to 80 % RH (no condensation) IMPORTANT Protecting the machine from condensation • To prevent condensation from forming inside the machine in the following cases, let the machine adjust to the ambient temperature and humidity for at least two hours before use. -- When the room where the machine is installed is heated rapidly -- When the machine is moved from a cool or dry location to a hot or humid location • If water droplets (condensation) form inside the machine, this can result in paper jams or poor print quality. When using an ultrasonic humidifier When you are using an ultrasonic humidifier, it is therefore recommended that you use purified water or other water that is free of impurities. If you use tap water or well water, impurities in the water will be dispersed through the air. This can be trapped inside the machine, causing degradation in print quality. Power Supply Requirements 120 to 127 V, 60 Hz IMPORTANT Precautions when connecting the power cord • Do not connect this machine to an uninterruptible power source. • Use an AC power outlet exclusively for the machine. Do not use the other sockets of the AC power outlet. • Do not plug the power plug into the auxiliary outlet on a computer. Do not use the same AC power outlet for both the machine and any of the following equipment. -- Copy machine -- Air conditioner -- Shredder -- Equipment that consumes a large amount of electricity -- Equipment that generates electrical noise • When unplugging the power cord, keep interval of 5 seconds or more before plugging it again. Miscellaneous precautions • The maximum power consumption of the machine is 1,100 W or less. • Electrical noise or a dramatic drop in supplied voltage may cause the machine or computer to operate incorrectly or lose data. Installation Requirements • A location with sufficient space • A location with good ventilation • A location with a flat, even surface • A location able to fully support the weight of the machine IMPORTANT Do not install the machine in the following locations, as this may result in damage to the machine. • A location subject to dramatic changes in temperature or humidity • A location subject to condensation • A poorly ventilated location (If you use the machine for a long time or to perform a large amount of printing in a poorly ventilated room, the ozone or other odors generated by the machine may create an uncomfortable working environment. In addition, chemical particles are dispersed during printing; therefore, it is important to provide adequate ventilation.) • A location near equipment that generates magnetic or electromagnetic waves • A laboratory or location where chemical reactions occur • A location exposed to salt air, corrosive gases, or toxic gases • A location, such as on a carpet or mat, that may warp from the weight of the machine or where the machine is liable to sink. Notes on wireless LAN • This product is designed for indoor use 164' /50 m (may vary on the communication speed or environmental condition) or less away from an access point. Keep it at an appropriately close distance. • Check if masking is found or not. Communications across walls or between floors are generally deteriorated. Arrange appropriate installment. • Radio wave interference may occur if any radiowave emitting equipment (i.e. microwave) is found near the product and its radiowave is in the same frequency band as the radiowave used by a wireless LAN. Keep the product away from those radio wave interference sources as much as possible. Installation Space Required installation space 50 3/8" (1,279 mm) 4" (100 mm) 4" (100 mm) 26 1/2" (672 mm) 4" (100 mm) 4" (100 mm) 4" (100 mm) 31 3/8" (795 mm) xviii