Canon PIXMA MX350 Network Setup Troubleshooting - Page 5

Multiple access points with the same name exist. is Displayed Check The message appears when multiple access points with the same name are found. When you have only one access point Select Use one AccessPoint only, then select the MAC address of the target access point. • For subsequent operations, go to or / / in "Entering the Access Point's Wireless LAN Settings Directly on the Machine" on page 9. • For details on how to check the MAC address of the access point, refer to the manual supplied with the access point or contact its manufacturer. When using multiple access points Select Use multiple AccessPoints. • For subsequent operations, go to or / / Wireless LAN Settings Directly on the Machine" on page 9. in "Entering the Access Point's Glossary • MAC address A unique number assigned to each network device. The directly entered access point was not detected. is Displayed Check The message appears when no access point is found by the entered access point name/network name (SSID). Check 1 Is the entered access point name/network name (SSID) correct? Press the OK button to make sure that the entered access point name/network name (SSID) is correct, then press the OK button again. Check 2 Make sure that you follow Check 1, 2, 5 and 6 of "Connection Checklist" on page 12. • After that, press the OK button, then proceed with the setup from in "Entering the Access Point's Wireless LAN Settings Directly on the Machine" on page 9. Check 3 Turn off the access point, then turn it back on. • After that, press the OK button, then proceed with the setup from in "Entering the Access Point's Wireless LAN Settings Directly on the Machine" on page 9. Check 4 Is the MAC address filtering enabled on the access point? • For details on how to check the settings of the access point, refer to the manual supplied with the access point or contact its manufacturer. Set the access point to accept the MAC address of the machine. • After that, press the OK button, then proceed with the setup from in "Entering the Access Point's Wireless LAN Settings Directly on the Machine" on page 9. • For details on how to change the settings of the access point, refer to the manual supplied with the access point or contact its manufacturer. • To check the MAC address of the machine, press the Setup button, then using the { } [ ] and OK buttons, select Device settings > LAN settings > Confirm LAN settings > WLAN setting list, then check MAC address.