Canon PIXMA SELPHY DS700 DS700 Photo Print Guide - Page 67
The Remote Control is not Working, A Message is Displayed on TV
View all Canon PIXMA SELPHY DS700 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 67 highlights
The Remote Control is not Working Troubleshooting Possible Cause Try This The distance between the remote control and the printer is too long/ there is an obstruction • Aim the remote control at the remote control receiver on the printer and bring it closer. • Remove the obstruction if there is any impediment between the remote control and the printer. • The remote control may operate improperly if strong light such as sunlight hits the remote control receiver. Change the installation location, or reduce the light with curtains. The battery is out of use. Replace with the new battery if the remote control does not work. See "Setting or Replacing the Battery" on page 10. The lithium coin cell battery CR2025 is available for this remote control. Purchase the commercial battery for replacement. A Message is Displayed on TV If a message is displayed on TV, take the corresponding countermeasure described below. Message/Error Try This No photos stored in a Photo data edited or processed on the computer should be printed memory card. from the computer, not from the camera. Ink tank may have been replaced. • If the ink tank has been replaced with a new one. Select Yes to reset the ink counter. See "Resetting the Ink Counter" on page 62. • If the ink tank has been removed for a certain period (the ink tank has not been replaced) Select No on the dialog box described above. Ink is almost empty. The '!' show a low ink level in the ink tank. A new ink tank (BCI-16 Color) should be prepared. Waste ink absorber* almost full. Press the RESUME/CANCEL button to recover from the error. You can print photos for a while but you cannot print any more photos when the waste ink absorber becomes full. Contact a Canon service representative. Read-write mode enabled. The memory card utility started on the computer has write-enabled the card slot. When the card slot is write-enabled, the printer cannot print photos. When you have finished writing data to the card, select the readonly mode. For the cancellation procedure, refer to the on-screen User's Guide. Cannot communicate Disconnect the camera cable, press the printer's RESUME/CANCEL with a connected device. button and reconnect the cable. If the error is still unresolved, there is a possibility that you are using a digital camera or digital video camcorder that is not supported by this printer. Use digital cameras or video camcorders that are compatible with this printer. 65