Canon imagePROGRAF W6400 HDI-E.pdf - Page 21

imagePROGRAF HDI Driver Guide Setting Up a Print Job Between Pages presents the following items for selection. Between Pages Printer Default None 30 sec., 1 min., 3 min., 5 min., 10 min., 30 min., 60 min. Setting Details This item resets the value to the printer default settings. Cancels the ink drying time. After the print job finishes, the printer waits for this time to elapse and then ejects the printed sheet. If the ink on the printed media is difficult to dry, increase the time with a higher setting. 2. If the ink is running or smearing on the printed output, from the Between Scans list under Drying Time select a time for the ink to dry between scans during printing. Between Scans presents the following items for selection. Between Scans Printer Default None 1 sec., 3 sec., 5 sec., 7 sec., 9 sec. Setting Details This item resets the value to the printer default settings. Cancels the ink drying time. Increase this setting if you see stains on the printed sheets or blurred colors in printouts done with borderless printing. 3. Click the OK button. Roll Paper Margin for Safety If the printed image appears rough or scratched by the printhead, adjust the settings for Near End Margin and Far End Margin. 1. In the Media Detailed Settings dialog box select a setting from the Near End Margin list under Roll Paper Margin for Safety. Near End Margin presents the following items for selection. Near End Margin Printer Default 5 mm 20 mm Setting Details This item resets the value to the printer default settings. Select this setting when you are not experiencing problems. Prints a standard size margin. Select this setting if the media has a strong tendency to curl, causing the printhead to scratch its surface. This setting sets the margin about 15 mm (in the feed direction) longer than the standard margin for the media size. 2. In the Media Detailed Settings dialog box, select a setting from the Far End Margin list under Roll Paper Margin for Safety. Far End Margin presents the following items for selection. Far End Margin Printer Default 5 mm 10 mm Setting Details This item resets the value to the printer default settings. Select this setting when you are not experiencing problems. Prints a standard size margin. Select this item when the cutter is fouling the printout as a result of dry ink that adheres to the cutter after it has cut sheets where printing was done as far as the trailing edge. This setting sets the margin about 5 mm (in the feed direction) longer than the standard margin for the media size. 3-8