Celestron Travel Scope 60 DX Portable Telescope with Smartphone Adapter Travel - Page 2

QUICK SETUP GUIDE 60 DX ENGLISH #22007 1 2 3 Unpack your telescope and verify that all parts are present. Your Travel Scope 60 DX includes: a telescope tube, a tripod and mount head, two eyepieces, a 3x Barlow lens, a finderscope, an erect image diagonal, a smartphone adapter, a Bluetooth shutter remote, a Robert Reeves' Lunar Landscapes book download card, and a travel backpack. To set up the tripod, spread the legs outward until they are fully extended and push down on the center leg brace. Extend the legs of the tripod by unlocking the three tripod lock levers on each leg. Pull each leg section all the way out and push the lever on each lock downward to secure it in place. 4 5 6 To extend the tripod's central column, turn the locking knob counterclockwise, lift up the tripod head until it is at the desired height and turn the locking knob clockwise to secure. Loosen the knob on the side of the tripod head mounting platform and rotate the platform 90 degrees so it is standing vertically. Match the threaded bolt in the mounting platform to the threaded hole on the bottom of the telescope tube and thread the two together. Do not overtighten. This should be snug, but not tight. 7 8 9 Rotate the mounting platform so it is horizontal and tighten the knob to secure it. Remove the cap from the focuser end of the telescope tube and make sure the two thumbscrews do not protrude into the opening. Locate the erect image diagonal and remove the plastic covers. Insert the barrel of the diagonal into the focuser and secure in place by tightening the set screws. ENGLISH | 1