Cisco 2950 Software Configuration Guide - Page 149

65727 Chapter 7 Clustering Switches Figure 7-13 Inventory Window Using the CLI to Manage Switch Clusters 12.1(4)EA1 10.10.10.6 10.10.10.7 12.0(5)WC2 10.1.1.2, 10.10.10.1, 10. 12.1(4)EA1 10.10.10.2 10.10.10.3 12.1(6)EA2 10.10.10.9 13.0(5)XU If you lose connectivity with a member switch or if a command switch fails, see the "Using Recovery Procedures" section on page 32-1. For more information about creating and managing clusters, refer to the online help. For information about the cluster commands, refer to the switch command reference. Using the CLI to Manage Switch Clusters You can configure member switches from the CLI by first logging into the command switch. Enter the rcommand user EXEC command and the member switch number to start a Telnet session (through a console or Telnet connection) and to access the member switch CLI. The command mode changes, and the CLI commands operate as usual. Enter the exit privileged EXEC command on the member switch to return to the command-switch CLI. This example shows how to log into member-switch 3 from the command-switch CLI: switch# rcommand 3 If you do not know the member-switch number, enter the show cluster members privileged EXEC command on the command switch. For more information about the rcommand command and all other cluster commands, refer to the switch command reference. The Telnet session accesses the member-switch CLI at the same privilege level as on the command switch. The CLI commands then operate as usual. For instructions on configuring the switch for a Telnet session, see the "Disabling Password Recovery" section on page 9-5. 78-11380-10 Catalyst 2950 and Catalyst 2955 Switch Software Configuration Guide 7-23