Cisco ASR1002-10G-VPN/K9 Software Guide - Page 109
show version, installed, show platform, ip tftp source-interface, GigabitEthernet 0, copy tftp, Step 1
View all Cisco ASR1002-10G-VPN/K9 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 109 highlights
Chapter 4 Software Upgrade Process ISSU Upgrade for Redundant Platforms DETAILED STEPS Step 1 Command or Action show version show version active-rp installed show version standby-rp installed dir filesystem: show platform Example: Router# show version Router# show version r0 installed Router# show version r1 installed Router# dir bootflash: Router# show platform Step 2 mkdir URL-to-directory-name Example: Router# mkdir usb0:221subs Step 3 ip tftp source-interface gigabitethernet slot/port Example: Router(config)# ip tftp source-interface gigabitethernet 0 Step 4 copy tftp: URL-to-target-location Example: Router# copy tftp: usb0:221subs Purpose (Optional) Use the following commands to confirm the current router configuration, as follows: • show version and show version active-rp installed-Verify the running version of the Cisco IOS XE software on the router, and which file was used to boot the router, and where that file is stored. • dir-Confirm that the files that were used to boot the router are located in the directory. • show platform-Confirm the current status of the active and standby RPs. Creates a directory to store the consolidated package and subpackages. This directory must be created in most cases because the consolidated packages and subpackages have to be separated from the subpackages that booted the router at this step of the procedure. Specifies the Gigabit Ethernet TFTP source-interface to be configured: slot/port-Specifies the location of the TFTP source-interface. Note To copy a file using TFTP through the Management Ethernet interface, the ip tftp source-interface GigabitEthernet 0 command must be entered before entering the copy tftp command. Copies the consolidated package file into the directory created in Step 2. The consolidated package in this step should not be copied into the same directory where the subpackages that are currently running your router are stored (the directory containing the packages.conf provisioning file from which the router was booted). Tip It is recommended that you copy the package onto a usb: or harddisk: file system for space considerations when performing this step of the procedure. OL-16506-10 Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide 4-47