Cisco ASR1002-10G-VPN/K9 Software Guide - Page 186
rpaccess, rpios, rpcontrol, show ip interface brief, sipbase, sipspa, Step 11
View all Cisco ASR1002-10G-VPN/K9 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 186 highlights
Upgrade Process With Service Impact for Nonredundant Platforms Chapter 4 Software Upgrade Process Command or Action Step 10 redundancy force-switchover Example: Router# redundancy force-switchover Purpose Force a switchover from the active IOS process to the standby IOS process. Note Your connection to the router often drops and is expected behavior at this point of the procedure in many scenarios. Step 11 Step 12 Step 13 If this step drops your connection to the router, wait a few minutes before reconnecting to the router and then continue to Step 11. (Optional) show platform Example: (Optional) Monitor system state to ensure both IOS processes are active. Router# show platform request platform software package install rp 0 file file-system:asr1000rp1-{rpaccess,rpios,rpcontrol }*version-string*.pkg bay standby-bay force Example: Router# request platform software package install rp 0 file bootflash:asr1000rp1-{rpaccess,rpios,rpcontrol} *02.02.01.122-33.XNB1*.pkg bay 0 force Upgrade the RPAccess, RPIOS, and RPControl subpackages in the standby bay, which in this context is the opposite bay used in Step 9. Note The pattern options used in this CLI (rpaccess, rpios, and rpcontrol) were introduced in Cisco IOS XE Release 2.1.2 and are not available in previous Cisco IOS XE Releases. See the "ISSU Procedures (Prior to Cisco IOS XE Release 2.1.2)" section on page 4-73 for pre-Cisco IOS XE Release 2.1.2 ISSU upgrade procedures. request platform software package install rp 0 file file-system:asr1000rp1-{sipbase,sipspa}*version*. pkg slot SIP-slot-number force Repeat this step for each SIP installed in your router before proceeding to the next step. Upgrade the SIP and SPA subpackages for each SIP on the router. Note This step must be completed one SIP at a time, and repeated for each SIP installed on the router before performing the next step. Example: Router# request platform software package install rp 0 file bootflash:asr1000rp1-{sipspa,sipbase}*02.02.01. 122-33.XNB1*.pkg slot 0 force Router# request platform software package install rp 0 file bootflash:asr1000rp1-{sipspa,sipbase}*02.02.01. 122-33.XNB1*.pkg slot 1 force Router# request platform software package install rp 0 file bootflash:asr1000rp1-{sipspa,sipbase}*02.02.01. 122-33.XNB1*.pkg slot 2 force Tip Note You can use the show ip interface brief command to identify which slots contain SIPs and SPAs. The interfaces with three numbers (in the form SIP-number/SPA-number/interface-number) identify the SIP and SPA locations in the router. The pattern options used in this CLI (sipbase and sipspa) were introduced in Cisco IOS XE Release 2.1.2 and are not available in previous Cisco IOS XE Releases. See the "ISSU Procedures (Prior to Cisco IOS XE Release 2.1.2)" section on page 4-73 for pre-Cisco IOS XE Release 2.1.2 ISSU upgrade procedures. 4-124 Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide OL-16506-10