Cisco ASR1002-10G-VPN/K9 Software Guide - Page 36
Table 2-5, Finding Command Options continued
View all Cisco ASR1002-10G-VPN/K9 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
Getting Help Chapter 2 Using Cisco IOS XE Software Table 2-5 Finding Command Options (continued) Command Router(config-if)# ? Interface configuration commands: . . . ip Interface Internet Protocol config commands keepalive Enable keepalive lan-name LAN Name command llc2 LLC2 Interface Subcommands load-interval Specify interval for load calculation for an interface locaddr-priority Assign a priority group logging Configure logging for interface loopback Configure internal loopback on an interface mac-address Manually set interface MAC address mls mls router sub/interface commands mpoa MPOA interface configuration commands mtu Set the interface Maximum Transmission Unit (MTU) netbios Use a defined NETBIOS access list or enable name-caching no Negate a command or set its defaults nrzi-encoding Enable use of NRZI encoding ntp Configure NTP . . . Router(config-if)# Router(config-if)# ip ? Interface IP configuration subcommands: access-group Specify access control for packets accounting Enable IP accounting on this interface address Set the IP address of an interface authentication authentication subcommands bandwidth-percent Set EIGRP bandwidth limit broadcast-address Set the broadcast address of an interface cgmp Enable/disable CGMP directed-broadcast Enable forwarding of directed broadcasts dvmrp DVMRP interface commands hello-interval Configures IP-EIGRP hello interval helper-address Specify a destination address for UDP broadcasts hold-time Configures IP-EIGRP hold time . . . Router(config-if)# ip Comment Enter ? to display a list of all the interface configuration commands available for the serial interface. This example shows only some of the available interface configuration commands. Enter the command that you want to configure for the interface. This example uses the ip command. Enter ? to display what you must enter next on the command line. This example shows only some of the available interface IP configuration commands. 2-10 Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide OL-16506-10