Cisco ESW-520-48P-K9 Software Guide - Page 113
show interface Command, Example 12-2 Viewing Status of Selected Interfaces, show interface
View all Cisco ESW-520-48P-K9 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 113 highlights
Chapter 12 Troubleshooting ATM Troubleshooting Commands This command sends end-to-end OAM F5 packets, which are echoed back by the aggregator. show interface Command Use the show interface command to display the status of all physical ports (Ethernet and ATM) and logical interfaces on the router. Table 12-1 describes messages in the command output. Example 12-2 Viewing Status of Selected Interfaces Router# show interface atm 0 ATM0 is up, line protocol is up Hardware is PQUICC_SAR (with Alcatel ADSL Module) Internet address is 14.0.0.16/8 MTU 1500 bytes, sub MTU 1500, BW 640 Kbit, DLY 80 usec, reliability 40/255, txload 1/255, rxload 1/255 Encapsulation ATM, loopback not set Keepalive not supported Encapsulation(s):AAL5, PVC mode 10 maximum active VCs, 1 current VCCs VC idle disconnect time:300 seconds Last input 01:16:31, output 01:16:31, output hang never Last clearing of "show interface" counters never Input queue:0/75/0 (size/max/drops); Total output drops:0 Queueing strategy:Per VC Queuing 5 minute input rate 0 bits/sec, 0 packets/sec 5 minute output rate 0 bits/sec, 0 packets/sec 512 packets input, 59780 bytes, 0 no buffer Received 0 broadcasts, 0 runts, 0 giants, 0 throttles 0 input errors, 1024 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort 426 packets output, 46282 bytes, 0 underruns 0 output errors, 0 collisions, 2 interface resets 0 output buffer failures, 0 output buffers swapped out Router# show interface fastethernet 0 Ethernet0 is up, line protocol is up Hardware is PQUICC Ethernet, address is 0000.Oc13.a4db (bia0010.9181.1281) Internet address is 170.1.4.101/24 MTU 1500 bytes, BW 10000 Kbit, DLY 1000 usec, reliability 255/255., txload 1/255, rxload 1/255 Encapsulation ARPA, loopback not set Keepalive set (10 sec) Router# show interface dialer 1 Dialer 1 is up, line protocol is up Hardware is Dialer interface Internet address is 1.1.1.1/24 MTU 1500 bytes, BW 100000 Kbit, DLY 100000 usec, reliability 255/255. txload 1/255, rxload 1/255 Encapsulation PPP, loopback not set Keepalive set (10 sec) DTR is pulsed for 5 seconds on reset LCP Closed OL-14210-01 Cisco Secure Router 520 Series Software Configuration Guide 12-3