Cisco ESW-520-48P-K9 Software Guide - Page 84
Example:, Con a GRE Tunnel
View all Cisco ESW-520-48P-K9 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 84 highlights
Configure a GRE Tunnel Chapter 7 Configuring VPNs Using an IPsec Tunnel and Generic Routing Encapsulation Step 2 Command or Action crypto map map-name Example: Router(config-if)# crypto map static-map Router(config-if)# Step 3 exit Example: Router(config-if)# exit Router(config)# Purpose Applies the crypto map to the interface. See the Cisco IOS Security Command Reference for more detail about this command. Enters global configuration mode. Configure a GRE Tunnel Perform these steps to configure a GRE tunnel, beginning in global configuration mode: Step 1 Command or Action interface type number Example: Router(config)# interface tunnel 1 Router(config-if)# Purpose Creates a tunnel interface and enters interface configuration mode. Step 2 ip address ip-address subnet mask Assigns an address to the tunnel. Example: Router(config-if)# ip address 10.62.1.193 255.255.255.255 Router(config-if)# Step 3 tunnel source interface-type number Example: Router(config-if)# tunnel source fastethernet 0 Router(config-if)# Specifies the source endpoint of the router for the GRE tunnel. Step 4 tunnel destination default-gateway-ip-address Example: Router(config-if)# tunnel destination 192.168.101.1 Router(config-if)# Specifies the destination endpoint of the router for the GRE tunnel. Cisco Secure Router 520 Series Software Configuration Guide 7-8 OL-14210-01