Cisco ESW-520-48P-K9 Software Guide - Page 31
Configuring Dynamic Routes, Configuring RIP, Example:
View all Cisco ESW-520-48P-K9 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
Chapter 1 Basic Router Configuration Configuring Dynamic Routes ia - IS-IS inter area, * - candidate default, U - per-user static route o - ODR, P - periodic downloaded static route Gateway of last resort is not set 10.0.0.0/24 is subnetted, 1 subnets C 10.108.1.0 is directly connected, Loopback0 S* 0.0.0.0/0 is directly connected, FastEthernet0 Configuring Dynamic Routes In dynamic routing, the network protocol adjusts the path automatically, based on network traffic or topology. Changes in dynamic routes are shared with other routers in the network. The Cisco routers can use IP routing protocols, such as Routing Information Protocol (RIP), to learn routes dynamically. You can configure either of these routing protocols on your router. Configuring RIP Perform these steps to configure the RIP routing protocol on the router, beginning in global configuration mode: Step 1 Command router rip Example: Router# configure terminal Router(config)# router rip Router(config-router)# Task Enters router configuration mode, and enables RIP on the router. Step 2 version {1 | 2} Specifies use of RIP version 1 or 2. Example: Router(config-router)# version 2 Router(config-router)# Step 3 network ip-address Example: Router(config-router)# network 192.168.1.1 Router(config-router)# network 10.10.7.1 Router(config-router)# Specifies a list of networks on which RIP is to be applied, using the address of the network of directly connected networks. OL-14210-01 Cisco Secure Router 520 Series Software Configuration Guide 1-11