Cisco ESW-520-48P-K9 Software Guide - Page 55
default, show running-config, access-list, permit, Step 10
View all Cisco ESW-520-48P-K9 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 55 highlights
Chapter 4 Configuring PPP over ATM with NAT Configuration Example Command Step 10 exit Purpose Exits configuration mode for the ATM interface. Example: Router(config-if)# exit Router(config)# Step 11 access-list access-list-number {deny | permit} source [source-wildcard] Example: Router(config)# access-list 1 permit 192.168.1.0 0.0.0.255 Defines a standard access list permitting addresses that need translation. Note All other addresses are implicitly denied. Note If you want to use NAT with a virtual-template interface, you must configure a loopback interface. See Chapter 1, "Basic Router Configuration," for information on configuring the loopback interface. For complete information on NAT commands, see the Cisco IOS Release 12.3 documentation set. For more general information on NAT concepts, see Appendix B, "Concepts." Configuration Example The following configuration example shows a portion of the configuration file for a client in the PPPoA scenario described in this chapter. The VLAN interface has an IP address of 192.168.1.1 with a subnet mask of 255.255.255.0. NAT is configured for inside and outside. Note Commands marked by "(default)" are generated automatically when you run the show running-config command. ! interface Vlan1 ip address 192.168.1.1 255.255.255.0 ip nat inside ip virtual-reassembly (default) ! interface ATM0 no ip address ip nat outside ip virtual-reassembly no atm ilmi-keepalive pvc 8/35 encapsulation aal5mux ppp dialer dialer pool-member 1 ! dsl operating-mode auto ! interface Dialer0 ip address negotiated OL-14210-01 Cisco Secure Router 520 Series Software Configuration Guide 4-9