Clifford Matrix 3 Owners Guide - Page 17

cessor will also record and report any triggers that occurred during your absence. ➜ arming diagnostics If the system is armed while an input is active (door open, sensor triggering, etc.) the unit will chirp once when arming and then one more time a few seconds later. This is called Bypass Notification. note: Bypass Notification will not occur when using Remote Controlled Chirp Muting or if chirps have been programmed OFF. The security system will ignore the input that was active when the system was armed, until the input goes away. Three seconds later the system will monitor that input normally. For example, if your vehicle has interior light exit delay, and you arm the system before the interior light goes out, you may hear Bypass Notification chirps. Once the light shuts off, however, the doors are monitored normally. ➜ disarming diagnostics Extra disarm chirps are the Tamper Alert. If four chirps are heard when disarming, the system was triggered in your absence. If five chirps are heard, a zone was triggered so many times that False Alarm Control Technology (FACT) has bypassed that zone. In either case, the LED status indicator will indicate which zone was involved (see Table of Zones section). The system will retain 14 © 2001 directed electronics, inc.