Compaq 470007-802 Deskpro EN Series of Personal Computers Maintenance and Serv - Page 57
drive cage., Insert the left side of the drivelock with the rounded tabs into the slots on
View all Compaq 470007-802 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 57 highlights
10. Press in on the tabs to release the vertical drivelock from the chassis, then lift it up and out of the system while at the same time rotating the drivelock slightly to clear the travel slots at the bottom of the drivelock. 11. Remove the spring from the post (see inset). To reinstall the vertical drivelock, reverse the previous procedure. To reinstall the horizontal drivelock: 1. Insert the left side of the drivelock (with the rounded tabs) into the slots on the drive cage. 2. Place the washer on the middle tab on the underside of the drivelock. 3. Compress the spring, then lower the drivelock onto the drive cage until it snaps into place. 4-20 Removal and Replacement Procedures
4-20
Removal and Replacement Procedures
10.
Press in on the tabs to release the vertical drivelock from the chassis, then lift it up and
out of the system while at the same time rotating the drivelock slightly to clear the
travel slots at the bottom of the drivelock.
11.
Remove the spring from the post (see inset).
To reinstall the vertical drivelock, reverse the previous procedure.
To reinstall the horizontal drivelock:
1.
Insert the left side of the drivelock (with the rounded tabs) into the slots on the
drive cage.
2.
Place the washer on the middle tab on the underside of the drivelock.
3.
Compress the spring, then lower the drivelock onto the drive cage until it snaps
into place.