Compaq Armada 7300 33.6Kbps Modem Commands for Armada 7000 Family of Personal - Page 21
Recall Profile on Power-Up &Y, Store Active Profile &W, Store Telephone Number &Z,
View all Compaq Armada 7300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
: 3 +,7( $3(5 (cont.) NOTE: The &Zn command must not be followed by another command on the same command line. . . Parameters: 0, 1 . . n = 0 Selects 39%-61% make/break ratio (Default). . . n = 1 Selects 33%-67% make/break ratio. . . Recall Profile on Power-Up (&Y) . . This command selects which stored profile will be made active after a reset or upon power- . up. . . n = 0 Recall stored profile 0 (Default). . . n = 1 Recall stored profile 1. . . . Store Active Profile (&W) . This command saves the active profile to the specified stored profile. . . Parameters: 0, 1 . . n = 0 Save active profile to stored profile 0. . . n = 1 Save active profile to stored profile 1. . . . &W may be used to create a separate profile for dialing noncellular calls and a separate profile for dialing cellular direct calls. . . . Store Telephone Number (&Z) . The modem can store up to four telephone numbers. Each telephone number dial string can . . . contain up to 36 characters. The format is AT&Zn=s, where n is the desired location from 03 and s is the dial string. . . EXAMPLE: AT &Z3=1(214)748-1414 . This stores the specified dial string in stored number location 3. . . . . Telephone Interface Control (&J) . This command specifies telephone jack selection. . . Parameters: 0, 2, 3 . . n = 0 Auto selection mode (Default). . . n = 2 Internal DAA (RJ-11 type only). . n = 3 Cellular direct connection. . . When the &J0 command is in effect, the modem automatically determines which type of . telephone interface is in use, then proceeds with the call. . . This autoselection takes some time and may be bypassed for quicker response by using &J2 . . . or &J3. When the &J3 command is entered, the modem will attempt to register with a cellular phone (if selected) to receive incoming calls. Even if one of these is selected in the . power-up profile, it is necessary to enter the command in order to attempt this registration. . . . . .