Compaq ProLiant 8500 Compaq ProLiant 8500 I/O Module Upgrade Guide - Page 30

Removing the Virtual Power Button Cable, Removing Cable Segment

Get Compaq ProLiant 8500 PDF manuals and user guides View all Compaq ProLiant 8500 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 30 highlights

26 Compaq ProLiant 8500 Server I/O Module Upgrade Guide Removing the Virtual Power Button Cable If your server was installed with a three-segment virtual power button cable, it must be removed. Each segment of the virtual power button cable is labeled A through C and has factory-installed self-adhesive cable guides. NOTE: Refer to the Compaq Remote Insight Lights-Out Edition User Guide for additional information on the virtual power button feature of the option board. Removing Cable Segment A Cable segment A of the virtual power button cable is located in the media module. Viewing the server from the front, remove the media module by following these steps:  1. Push in on the sides of the cam levers on the media module and rotate  the top of the levers downward . 2. Pull the media module out of the chassis until it makes contact with the module stop latch.  3. Press in the module stop latches and pull the module out of the  chassis . 1 2 3 4 Figure 18. Removing the media module

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
26
Compaq ProLiant 8500 Server I/O Module Upgrade Guide
Removing the Virtual Power Button
Cable
If your server was installed with a three-segment virtual power button cable, it
must be removed. Each segment of the virtual power button cable is labeled A
through C and has factory-installed self-adhesive cable guides.
NOTE:
Refer to the
Compaq Remote Insight Lights-Out Edition User Guide
for additional
information on the virtual power button feature of the option board.
Removing Cable Segment A
Cable segment A of the virtual power button cable is located in the media
module. Viewing the server from the front
,
remove the media module by
following these steps:
1.
Push in on the sides of the cam levers
on the media module and rotate
the top of the levers downward
.
2.
Pull the media module out of the chassis until it makes contact with the
module stop latch.
3.
Press in the module stop latches
and pull the module out of the
chassis
.
3
4
1
2
Figure 18.
Removing the media module