D-Link DBS-2000-10 Nuclias Manual - Page 52
Configuring Basic SSID Settings
View all D-Link DBS-2000-10 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 52 highlights
End IP Subnet mask Gateway Primary Secondary clients. Enter the starting IP address of the pool. Only IP address within the start/end range will be assigned to clients. Enter a valid subnet mask. Enter a valid gateway address. Enter a primary DNS server address. Enter a secondary DNS server address. 14. Choose to enable or disable VLAN. 15. If VLAN is enabled, specify the following information: Note: If VLAN and NAT mode are both enabled, the device's IP connection setting must be configured to use the same VLAN in order to connect to the Internet. Refer to the Editing a Device section on page 64. VLAN mode VLAN tag Select the VLAN type. Tagged: Adds an 802.1Q header to traffic. Untagged: Does not add a tag to traffic. If the VLAN mode is set to Tagged, specify a VLAN tag. This will segment traffic with the respective VLAN tag. 16. Choose to enable or disable Station Isolation. This prevents clients connected to the same SSID from communicating with each other. 17. Choose to enable URL redirection. 18. If URL redirection is enabled, specify the following information: URL for redirection Redirection interval Enter the URL clients connecting to the SSID will be redirected to. Enter the time (in minutes) clients will be periodically redirected to the URL. 19. Click Save. 20. Click Push Configuration. 8.1.5.3 Configuring Basic SSID Settings 44