D-Link DGS-6600-48TS CLI Guide - Page 280

DGS-6604 ip igmp query-max-response-time ip igmp query-max-response-time Use this command to configure the maximum response time advertised in IGMP queries. ip igmp query-max-response-time SECONDS Syntax Description SECONDS Set the maximum response time, in seconds, advertised in IGMP queries.The range is 1 to 25. Default Command Mode Usage Guideline Example 10 seconds VLAN interface configuration This command controls the period during which the group member can respond to an IGMP query message before the router deletes the membership. This command applies to interfaces configured for both IGMP Layer-3 multicast protocols and IGMP Snooping (L2 mode and the interface function as a querier). The group membership interval is equal to query-interval* robustness + max response time. This example shows how to configure IGMP max query response time to 10 seconds on VLAN 1000. Switch# configure terminal Switch(config)# interface vlan1000 Switch(config-if)# ip igmp query-max-response-time 10 Switch(config-if)# end Verify the settings by entering the show ip igmp interface command. CLI Reference Guide 270