D-Link DGS-6600-48TS CLI Guide - Page 883

DGS-6604 m spanning-tree priority spanning-tree priority This command configures the bridge priority and is only used for RSTP and STP versions. Use the no form of this command to restore to default setting. spanning-tree priority PRIORITY no spanning-tree priority Syntax Description PRIORITY The bridge priority and bridge MAC Address together form the Spanning-Tree Bridge-ID, which is an important factor in the Spanning-Tree Topology. The range is 0 to 61440. Default Command Mode Usage Guideline Example PRIORITY: 32768 Global configuration Bridge Priority is one of the two parameters used to select the Root Bridge. The other parameter is the system's MAC address. The bridge priority value must be divisible by 4096, and a lower priority value (number) represents a higher priority. This configuration will take effect only when using STP version and RSTP mode. In MSTP mode, use the command "spanning-tree mst priority" on page 871 to configure the priority for an MSTP instance. This example shows how to configure the STP bridge priority to 4096. Switch(config)# spanning-tree priority 4096 Verify the settings by entering the show spanning-tree command CLI Reference Guide 873