D-Link DGS-6600-48TS CLI Guide - Page 412

DGS-6604 m logging host logging host Use the logging host command to log system messages to a remote host. Remove logging hosts from the configuration with the no logging host command. logging host IPADDRESS [port UDP-PORT] [severity {emergency |alert |critical |error |warning |notice |informational | debugging}] [facility {local0|local1| local2| local3| local4| local5| local6| local7}] no logging host [IP-ADDRESS] Syntax Description IP-ADDRESS Specifies the IP address of the host to be used as the syslog server. IPv4 and IPv6 address are supported. port UDP-PORT (Optional) The UDP port number to be used for the syslog server. Valid values are 514 or any value from 1024 to 65535. severity (optional) Specifies the severity of log messages that will be sent to the server. emergency System is unusable. alert Action must be taken immediately. critical critical condition error error conditions warning warning condition notice normal but significant condition informational informational message debugging debugging message facility (optional) Specifies the facility (refer to options listed in the below rows) in the log messages to be sent to the server. local0 local use 0 local1 local use 1 local2 local use 2 local3 local use 3 local4 local use 4 local5 local use 5 local6 local use 6 local7 local use 7 Default IP-ADDRESS: None UDP port: 514. severity: informational CLI Reference Guide 402