D-Link DGS-6600-48TS CLI Guide - Page 405

DGS-6604 m lldI p run lldp run no lldp run Syntax Default Command Mode Usage Guideline Example lldp run To enable Link Layer Discovery Protocol (LLDP) globally, use the lldp run command in global configuration mode. Use the no form of this command to return to the default settings. This command has no arguments or keywords. LLDP global state is disabled. Global configuration This is a global control for the LLDP function. You can use lldp run in global configuration mode to globally enable LLDP, and then the switch can start to transmit LLDP packets and receive and process the LLDP packets. However, the transmission and receiving of LLDP can be controlled respectively by the command lldp transmit and lldp receive in interface configuration mode. LLDP takes effect on a physical interface only when it is enabled both globally and on the physical interface. By advertising LLDP packets, the switch announces the information to its neighbor through physical interfaces. On the other hand, the switch will learn the connectivity and management information from the LLDP packets advertised from the neighbor(s). This example shows how to globally enable LLDP: Switch(config)# lldp run This example shows how to globally disable LLDP. Switch(config)# no lldp run CLI Reference Guide 395