Dacor ERD30 Installation Instruction - Epicure Range - Page 8

Installation Instructions - manual

Page 8 highlights

Installation Instructions WARNING • Observe all governing codes and ordinances during planning and installation. Contact your local building department for further information. • If the gas or electric service provided does not meet the product specifications, do not proceed with the installation. Call the selling dealer, the gas supplier or a licensed electrician. • This appliance must be installed by a licensed plumber or gas fitter when installed within the Commonwealth of Massachusetts. Verifying the Package Contents Verify that all required components have been provided. If any item is missing or damaged, please contact your dealer immediately. Do not install a damaged or incomplete appliance. • Use and care manual • Ignitor cleaning kit • Broiler pan/grill • Anti-tip bracket (selected models) • Grate/burner cap packs • Griddle • Burner rings • Wok ring • Simmer plate • Spatula • Stainless steel cleaner • Lens pry stick (selected models) Installing the Anti-Tip BrHaincgekCeatcth (Models ERD30 and EGR30 Only) 30" ranges require an anti-tip device. Before installing the range, you must locate the anti-tip bracket in the product packaging and secure it to the floor as shown below. Door Removal To make the range easier to move during installation, remove the door(s) before installation. WARNING • Do not attempt to disengage the hinge catches with the door removed from the oven. The hinge springs could release causing personal injury. • Do not lift or carry the oven door(s) by the door handle. 1. Open the door to its fully opened position. 2. Rotate the catch over the retaining arm on each hinge. Hinge Catch To remove doo,r rotate catch up. 3. Lift the oven door to about a 30 degree angle from the horizontal position. 8 3/8" (213mm) 2 3/16" (56mm) To remove doo,r rotate catch up. Rear Wall 3 7/8" (98mm) 1 1/2" (38mm) Lift door up to 30° angle, then pull door away 30° from the range oven section. 4. Pull the door away from the oven while continuing to lift. Floor 30 1/16" (763m) Min. Installation of ERD30/EGR30 Anti-Tip Bracket Top View 6

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16

6
Door Removal
To make the range easier to move during installation, remove the
door(s) before installation.
WARNING
Do not attempt to disengage the hinge catches with the
door removed from the oven. The hinge springs could
release causing personal injury.
Do not lift or carry the oven door(s) by the door handle.
Open the door to its fully opened position.
1.
Rotate the catch over the retaining arm on each hinge.
2.
Lift the oven door to about a 30 degree angle from the
3.
horizontal position.
Pull the door away from the oven while continuing to lift.
4.
WARNING
Observe all governing codes and ordinances during
planning and installation. Contact your local building
department for further information.
I
f the gas or electric service provided does not meet the
product specifications, do not proceed with the installation.
Call the selling dealer, the gas supplier or a licensed
electrician.
This appliance must be installed by a licensed plumber
or gas fitter when installed within the Commonwealth of
Massachusetts.
Verifying the Package Contents
Verify that all required components have been provided. If
any item is missing or damaged, please contact your dealer
immediately. Do not install a damaged or incomplete appliance.
Use and care manual
Ignitor cleaning kit
Broiler pan/grill
Anti-tip bracket (selected models)
Grate/burner cap packs
Griddle
Burner rings
Wok ring
Simmer plate
Spatula
Stainless steel cleaner
Lens pry stick (selected models)
Installing the Anti-Tip Bracket
(Models ERD30 and EGR30 Only)
30” ranges require an anti-tip device. Before installing the range,
you must locate the anti-tip bracket in the product packaging and
secure it to the floor as shown below.
Installation Instructions
Rear Wall
8 3/8”
(213mm)
30 1/16"
(763m) Min.
Floor
2 3/16”
(56mm)
1 1/2" (38mm)
3 7/8" (98mm)
Installation of ERD30/EGR30 Anti-Tip Bracket
Top View
To remove door
,
rotate catch up.
Hinge Catch
Lift door up to 30° angle,
then pull door away
from the range oven section.
30°