Dell C1048P Port Extender Networking C1048P Getting Started Guide - Page 20

command. The cascade ports must be operationally up (no shutdown command) and have a default port configuration with no L2 and L3 configuration. The port interfaces must be the same type. You can configure up to eight C9010 ports in the auto-LAG. The generated auto-LAG number is from 257 to 513. PORT-EXTENDER CONFIGURATION mode Dell(conf-pe-0)# cascade interface interface-type slot/port-range • interface interface-type specifies a C9010 10-Gigabit Ethernet interface. The only supported value is TenGigabitEthernet slot/port-range. • slot/port-range specifies a C9010 10GbE port, including slot number and either a single port number, a port range, or a combination of both for auto-LAG configuration. - The range of slot numbers is from 0 to 11. In line-card slots 0 to 9, the range of port numbers is from 0 to 23; in RPM slots 10 and 11, the range of port numbers is from 0 to 3. - Enter a port range with or without spaces; for example, cascade interface tengigabitethernet 0/1-5 or cascade interface tengigabitethernet 0/1 - 5. - You can enter up to six comma-separated ranges or port numbers; for example, cascade interface tengigabitethernet 0/1-2,8,10-12,15. 5. Verify the provisioned configuration on a C1048P. EXEC Privilege mode Dell# show pe brief Dell# show pe pe-id Dell# show interface port-channel brief Example of Provisioning a Port Extender Dell(conf)# feature extended-bridge Dell(conf)# pe provision 2 Dell(conf-pe-2)# stack-unit 0 type c1048p Dell(conf-pe-2)# cascade interface tengigabitethernet 0/1-2 Dell(conf-pe-2)# exit Dell(conf)# interface range tengigabitethernet 0/1-2 Dell(conf-if-te-0/1-2)# no shutdown Dell(conf-if)# end Dell# show pe brief -- Port Extenders Information -- PE-id Status Stack-size Type System-MAC 2 online 1 C1048P 34:17:eb:00:bb:11 NOTE: If the status of a port extender is error, communication with an attached C9010 was unsuccessful, possibly due to a mismatch in software version (SVM) or another communication error. Wait five minutes for an auto-upgrade of the port extender to complete. If the status does not change to online, contact Dell Networking Support for assistance. Dell# show pe 2 Codes: A - Active, I - Inactive Reason: CTM - Card Type Mismatch, CAM - CAM ACL Mismatch SVM - Software Version Mismatch, UE - Unknown Error PE-ID assigned: 2 20 Configuring the Software