Dell C1048P Port Extender Networking C1048P Getting Started Guide - Page 22
Next Steps, Dell Networking Configuration Guide for C9000 Series, Switches
View all Dell C1048P Port Extender manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
Figure 9. C1048P Port Numbering 1. C1048P 10/100/1000BASE-T ports 1-48 Next Steps After you complete the initial C1048P provisioning, you can configure L2 software features on the C1048P from the C9010 console CLI, including LLDP, 802.1x, LACP, loop detection and BPDU guard. No other L2 protocols are supported. IP address and L3 protocol configuration on C1048P ports are not supported. For detailed information, see the Dell Networking Configuration Guide for C9000 Series Switches. When the C1048P is online, you can enter the connect pe pe-id command on the C9010 console to remotely log in to the C1048P CLI. To log in, enter the user name peadmin and the password calvin. After logging in, you can enter show and stack renumbering commands on the C1048P. To move through command modes in the C1048P CLI, see the Command Modes section in the Dell Networking C9010 Getting Started Guide. 22 Configuring the Software