Dell Inspiron 27 7720 All-in-One Owners Manual - Page 57
Installing the M.2 2230 solid-state drive
View all Dell Inspiron 27 7720 All-in-One manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 57 highlights
The following image indicates the location of the solid-state drive and provides a visual representation of the removal procedure. Steps 1. Remove the screw (M2x3.5) that secures the solid-state drive to the system board. 2. Slide and remove the solid-state drive from the M.2 card slot on the system board. Installing the M.2 2230 solid-state drive Prerequisites CAUTION: Solid-state drives are fragile. Exercise care when handling the solid-state drive. If you are replacing a component, remove the existing component before performing the installation procedure. About this task NOTE: The M.2 card installed on your computer will depend on the configuration ordered. The supported card configurations on the M.2 card slot are: ● M.2 2230 solid-state drive ● M.2 2280 solid-state drive NOTE: This procedure applies if you are installing an M.2 2230 solid-state drive. If you are replacing an M.2 2280 solid-state drive with an M.2 2230 solid-state drive, move the screw mount as shown in the following figure, before you perform the other steps in the installation procedure. Removing and installing Customer Replaceable Units (CRUs) 57